Thingiverse
Traeger Grill Upgrades
von 512Designs
131
Downloads
67
Likes
0
Makes
All pieces were designed to use M4 hardware. I marked and drilled holes to attach every piece. I've tested the pieces by grilling at 450ºF and they were nowhere near the melting point of PETG. Please use common sense and mount the parts to the pellet hopper, not the grill enclosure.
The hooks use 2 embedded M4 nuts. Pause your print at 4.7mm layer height. Press in the nuts so that they are level with the print. Use a little bit of glue stick on the top of the nut so that the filament will stick to it when you resume the print.
The Can Holder was designed to fit both grill spray and beer cans.
The hooks use 2 embedded M4 nuts. Pause your print at 4.7mm layer height. Press in the nuts so that they are level with the print. Use a little bit of glue stick on the top of the nut so that the filament will stick to it when you resume the print.
The Can Holder was designed to fit both grill spray and beer cans.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
