Slicer Discord
Traffic Cone Clock Components Kit 011 – 3D-printbaar model van MakerWorld MakerWorld
Decor

Traffic Cone Clock Components Kit 011

321 Downloads
329 Likes
185 Makes
Model downloaden
UPDATE 2025/02/23Increased clock base size from 56.5mm to 57.5mm to accommodate differences in clocksAdded negative cylinders for Hours and Minutes cones with their respective diameters for you to editAdded a profile with test pieces, only 11m 2.5g print - Print this first to avoid unnecessary prints that don't fit your clockPrint the the test pieces and insert them on the clock to check for the best diameter. Needs to fit really tight, some force needed. If the best pieces are 5.1mm and 3.1mm, print as normal. If any doesnt fit, change the cylinder diameter to the best fit, center the cylinder, and print the cones! Note: Most clocks should be the same, but to eliminate doubts, print the test pieces first --------- end update ------------ TICK TOCK, IT'S TRAFFIC CONE O'CLOCK! Rejoice with this fun and inovative way to check the time! Pros:Tells timeLooks goodSpins!It's a traffic coneCons:You will waste time looking at it spin! Assembly:Insert the clock from below and sc
Categorie
Decor
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie