Thingiverse
Trailer door latch holder
by mx3_power
30
Downloads
16
Likes
0
Makes
The T arm part of a latch to hold a trailer door open.
Printed with 100% fill at 0.2mm.
It imports on its side but I flip it flat and use a raft and supports. It came out a bit rough on the bottom when I printed it out so I should have tweaked the supports a bit.
Printed with 100% fill at 0.2mm.
It imports on its side but I flip it flat and use a raft and supports. It came out a bit rough on the bottom when I printed it out so I should have tweaked the supports a bit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
