Thingiverse
Trailer Tarp Hook Anchor
von Mojo_JojoSK
0
Downloads
0
Likes
0
Makes
The place where my tarp covered trailer rope? fastener? mounted to in the first place broke after many years exposed to the elements. I decided to print one instead of the struggle to find the correct one.
Printed out of PETG using the following settings:
- Walls 2
- Infill 100% Concentric (30% gyroid should also suffice, I am paranoid about stuff like this)
- Alternating walls ON (helps to offset and capture the infill for added strength in all directions)
- laid on its side so the layers are inline with the large hole (the model was rendered flat and needed to be turned 90° in relation to the print bed)
Printed out of PETG using the following settings:
- Walls 2
- Infill 100% Concentric (30% gyroid should also suffice, I am paranoid about stuff like this)
- Alternating walls ON (helps to offset and capture the infill for added strength in all directions)
- laid on its side so the layers are inline with the large hole (the model was rendered flat and needed to be turned 90° in relation to the print bed)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
