Thingiverse
Trampoline net pole cap
door cjnaz
0
Downloads
1
Likes
0
Makes
These caps fit nicely on the net support poles. The slot on the side is for the net tie strap, and the hole is for a screw to secure the cap in position.
The ID is set at 1.35 inches. Print this in a high strength, high temperature plastic, such as ABS.
A Fusion360 model is included.
The ID is set at 1.35 inches. Print this in a high strength, high temperature plastic, such as ABS.
A Fusion360 model is included.
cjnaz publiceert ook op
39 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!