Transceiver module programmer BOX IICHIB-X2

有效减少模块因插拔引起的短路，写码失败，造成写码板损坏，磨花光模块外壳的概率提升5%以上的插拔成功率 (相比裸板)无损且简便安装，替换升级方便。（预留散热器安装位，是否安装根据需求选择）。400G的光模块5分钟可以达到70°！！！ 建议使用PETG-CF或PETG-HF(变形温度基本满足) 壳体选用铝合金，尺寸为108*26*100mm（注意买客体时选购喷砂的！切割处会安全一些避免划伤！）TB上搜铝壳就可以找到购买时不需要面板！（面板的孔径符合2M的螺丝，如果买的壳子面板安装孔径是3m就得大力安装）Effectively reduce the probability of short circuit caused by module insertion and removal, code writing failure, damage to the code board, and abrading the module shellIncrease the success rate of insertion and removal by more than 5% (compared to bare board)Non-destructive and easy installation, easy replacement and upgrade. (The heat sink installation space is reserved. Install the space as required.) 400G optical module can reach 70° in 5 minutes!! It is recommended to use PETG-CF or PETG-HF(deformation temperature is basically satisfied)The shell is made of aluminum alloy, the size is 108*26*100mm (pay attention to the choice of sandblasting when buying the object! The cut will be safer to avoid scratches!)No panel required when buyi