Trash bag holder

This is a lid designed to be hung and hold trash bags open, convenient for car, camping, volunteer cleanups etc. It is based off of Take-no-place Trash Can for kitchen or camping-car by cminssie. The original design used a rubber band to hold the trash bag and needed supports to print. I'm lazy and didn't want to go buy a rubber band or deal with supports so I edited the body to accept a ring that runs around the rim to hold a trash bag. The photos show a previous version I have since edited it to have the hanging loop attach to the ring instead of the body as it would end up covered by the bag and I tightened the tolerances slightly so the fit would be more secure. fits on a 220x220 print bed.

Printer brand:
Creality

Printer:
Ender3 v2 neo

Rafts:
Doesn't Matter

Supports:
No

Resolution:
.3mm

Infill:
25% Gyroid