Trash Can Lid-Hinge Pin Replacement

Replacement trashcan lid hinge pins. Fits LID hole diameter 0.55" / 14mm (depth .8" / 20mm), and BODY hole diameter 0.85" / 22mm. Other sizes available on request - comment with the needed measurements. Set of two pins requires 2x M6x50mm countersunk screws, and 2x M6 locknuts. Alternatively regular M6 nuts may be used with Loctite or similar. PRINT WITH PETG FOR WEATHER-RESISTANCE Assembly instructions: Remove any existing broken hinge parts from lid/trashcan Drill hole in outside of lid hinge pin area, to fit screw Insert locknut into hex hole in base of pin (nylon locking material facing OUT, not IN). Use oversize hex key to push in until it bottoms out. Ensure nut is concentric with the through-hole. If it's crooked it may not thread right Insert hex hole end of pin into trashcan handle just enough that you can still slip the handle hinge part over it Insert M6 screw through washer, through drilled hole, and into pin Carefully grip pin with needlenose pliers, and screw in the screw