Thingiverse
Traverse 2018 Latches
von sa3aad
5
Downloads
1
Likes
0
Makes
Traverse 2018 Front Rear Latches
It is better to use ABS or any filament can handle the out side temperature to avoid wrapping (glass transition).
Note: The rear latch has larger holes but wider surface so you can use double sided tape to stick it on without removing the original screws.
It is better to use ABS or any filament can handle the out side temperature to avoid wrapping (glass transition).
Note: The rear latch has larger holes but wider surface so you can use double sided tape to stick it on without removing the original screws.
sa3aad veröffentlicht auch auf
5 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!