MakerWorld
RC
Go to Model
Traxxas Maxx V2 Cable Guide
13
Downloads
5
Likes
2
Makes
Use this wire channel to help keep the wire better contained inside the chassis. I have the light kit and I made a dual fan mount for the motor and had wire all over the place. I kept snagging the wire every time I put in or take out the battery plus I didn't like how the wires looked like a mess. Top holes allows you use zip ties to hold the wires in place. While the bottom triangles allows water to drain down away from the wires.Hardware required: 2 M3 cap screw/button head with about 11mm of thread.Note: this wire channel will not work with the V1 Maxx as the V2 Maxx has a longer chassis. Print Setting I used:.2mm layer2 wall15% infill with gyroid4 top layers and 3 bottom layersprinted out of PETG
Bobbalouie also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!