Thingiverse
Treasure Chest
by Zaggo
176
Downloads
247
Likes
10
Makes
Ok, this is a tough one.
This treasure chest is printed in one piece!
You definitely should be good friends with your MakerBot when printing this. ABS warping is a big problem. The few lucky ones with PLA on their desk definitely have the advantage here...
Anyway, you might give it a shot.
As usual with my quirky objects, Skeinforge is moaning and groaning when processing it. But if you configure "Carve" to use "unproven meshes" and ignore all warnings, you should get a printable gcode file :)
The attached gcode is the one I used for printing the treasure chest on the photo. It's suitable for MakerBots with a .5mm nozzle.
There's also a short video on this on YouTube: http://www.youtube.com/watch?v=wtoLPj_YOkA
This treasure chest is printed in one piece!
You definitely should be good friends with your MakerBot when printing this. ABS warping is a big problem. The few lucky ones with PLA on their desk definitely have the advantage here...
Anyway, you might give it a shot.
As usual with my quirky objects, Skeinforge is moaning and groaning when processing it. But if you configure "Carve" to use "unproven meshes" and ignore all warnings, you should get a printable gcode file :)
The attached gcode is the one I used for printing the treasure chest on the photo. It's suitable for MakerBots with a .5mm nozzle.
There's also a short video on this on YouTube: http://www.youtube.com/watch?v=wtoLPj_YOkA
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
