Tree Candy - Garden Lantern

Membership✨If you wanna sell my designs while looking out for me → Hey there! :) This, is the Tree Candy: a hanging and delicious-looking tea light lantern! I was going for a “garden fairy meets Wily Wonka” kinda vibe. I tried to keep this design as simple and accessible as I could. This print needs no support; the assembly is quite easy and intuitive, and I believe that it even suits a variety of colors of translucent filament. So I hope a lot of you can enjoy this cute candy light! How it works: This lantern is compatible with tealight candles with a diameter between 37 & 39 mm. It can be used both as a hanging lantern and a table-top light. The candle on & off button is accessible even after the assembly. How to print perfectly: Print with 0.2 mm layer heights. Make sure the support option is disabled. Enable the brims. The shade needs a relatively large brim, about 15 or 20 mm. Reduce the infill percentage to 0% for the shade. Instead, increase the wall count to 3. The infill for t