Tree Face - Version 2 (AMS Needed)

This model is a quick and easy print that is enjoyable by anyone! I got lots of great comments on my 1st tree face so I thought may as well upload a V2! The improvements for this one was, 1 I upscaled it to almost 2X the size. 2 I added notches around the side of the hole so you don't need magnets, instead you just need nails. 3 I changed allot of the print settings so it uses less filament. (it almost uses the same amount of filament as the smaller one). This model is very easy to assemble. What you need: 4 Nails Tree to hang it on Hammer What you need to print: Eyes Nose Mouth Start by hammering the nails in one at a time leaving each nail sticking out about 1 inch. (This is what the nails should look like). <