Thingiverse
Tree for Gloomhaven
by Robagon
7.9k
Downloads
4.1k
Likes
74
Makes
Overlay tile replacement for the board game Gloomhaven. Canopy is partially hollow and removable so you can see underneath if it gets in the way. No supports needed!
Tile Count: 3
Revisions:
V2: I would print V2 as the default for Gloomhaven, I tried to optimize this one for scale. It also has the most branches when the canopy is removed. The canopy rests on the top of the branches in one orientation.
V1: This older version has a little bigger canopy and thicker trunk/branches but is nice enough that I thought I'd include it. The canopy attaches to the base with three pins.
2019-12-08: Added a split canopy of V2 for smaller printers.
Check out my [cults3d.com](https://cults3d.com/en/users/RobagoN/creations) page for premium and multi-material models.
Tile Count: 3
Revisions:
V2: I would print V2 as the default for Gloomhaven, I tried to optimize this one for scale. It also has the most branches when the canopy is removed. The canopy rests on the top of the branches in one orientation.
V1: This older version has a little bigger canopy and thicker trunk/branches but is nice enough that I thought I'd include it. The canopy attaches to the base with three pins.
2019-12-08: Added a split canopy of V2 for smaller printers.
Check out my [cults3d.com](https://cults3d.com/en/users/RobagoN/creations) page for premium and multi-material models.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
