MakerWorld
Other House Models
Zum Modell
Tree Watering Funnel
86
Downloads
17
Likes
56
Makes
For literally decades I crawled under the tree to water it, usually spilling water in the process. But no more, now I have a long funnel! Designed so you hang the spout over the lip of the tree's stand and pour into the funnel end, it allows you to extend its length as needed to make the watering job easier. You can (in theory) make it as long as you need—within reason of course. I made it quite large so that water would flow quickly and freely. I use a pitcher to pour the water and sometimes it comes out pretty fast, that should not be an issue here. The print profile has a funnel, a spout, and 3 straight sections (160, 200 and 250 mm). Print as many straight sections as you need, one funnel and a spout. The straight sections are intended to print in vase mode for speed but the funnel and spout must be printed by layer (normal). The profile should have all that setup for you. Assembly: these are press fit—push together until they're snugly connected and don't fall off… the
Tawpie veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!