Tri-Angle Tablet Stand

All the tablet stands I saw on Thingiverse seemed to be to small or to complicated. My son has several tablets in the 10" range, and he wanted to be able to stand them at different angles on his desk (for reasons unknown).

This is my FIRST build from my own design. After I made the first one (well, actually three ...), he tested it/them. He suggested a small lip at the end of the "toggles" to grab the bottom edge. One of his tablets is pretty thin, one kinda thick. I made the lip for the thick one.

When properly assembled, the toggle will be perpendicular to the nearest edge. The incline angles are 45, 60 and 75 degrees. Not as many choices as some systems, but designed for his specific request.

All the parts were made to lay flat on my (rather small) build area of 120mm x 125mm. I actually printed the rods vertically. They are the only place I used supports.