Tri-Glide Trunk Latch Bezel

This is a replacement bezel for the lock on the trunk of a Harley Davidson Tri-Glide.

[Harley Forum Reference](https://www.hdforums.com/forum/tri-glide-and-freewheeler-models/1069486-tri-glide-trunk-latch-mechanism.html)

I printed this using ABS and standing up with the bezel face down which gave me the best strength at the break point.

Supports are needed but you must be careful withthe supports inside where the o-ring sits. If your supports are too close, then you will have a tough time cleaning that area out to insert the o-ring. I increased my pattern spacing to 2.5mm which allowed me to remove the supports easily.