Thingiverse
Triangle Labs Filament Sensor Bracket
por Tahrann
8
Descargas
3
Likes
0
Makes
Misc Notes
This bracket is meant to house the Triangle Labs Filament Sensor and should be a pretty close if not exact fit for the sensor. I had to print mine straight up (with the sensor opening pointing up) due to printing with PETG and poor bridging, but it comes out pretty strong.
Word of warning: Don't tighten the bracket too much or else it will cause the lead screw to bind. Also I did not get a chance to test this new version so any feedback will help greatly.
Other material needed: M3 x 8 or 10 screws.
Thanks all!
This bracket is meant to house the Triangle Labs Filament Sensor and should be a pretty close if not exact fit for the sensor. I had to print mine straight up (with the sensor opening pointing up) due to printing with PETG and poor bridging, but it comes out pretty strong.
Word of warning: Don't tighten the bracket too much or else it will cause the lead screw to bind. Also I did not get a chance to test this new version so any feedback will help greatly.
Other material needed: M3 x 8 or 10 screws.
Thanks all!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
