Thingiverse
Triangular edge paving brick mold
por Stockpiles
22
Descargas
16
Likes
0
Makes
Needed bricks and was too cheap to buy them.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Stockpiles también publica en
12 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
