Slicer Discord
Tricopter tail pivot V2 – 3D-printbaar model van Thingiverse Thingiverse

Tricopter tail pivot V2

door Kezat
39 Downloads
23 Likes
0 Makes
Model downloaden
Version two of the tail pivot system with built in landing gear for a Tricopter. Mounts to a 13mm wood boom.
Made for and Inspired by the Batbone from Flitetest.com.
No longer needs lexan plastic sheet to bolt the motors to.

For the front motor mounts see http://www.thingiverse.com/thing:351200

Let me know if you have any suggestions or have a specific motor you want this to be modded for.

IMPORTANT:
If your motors run too hot the PLA could melt causing a failure, for the first few flights monitor the temperature of the motors. I have about 20+ flights with the extra weight of FPV gear and have had no issues.

Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, Wood PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Kezat publiceert ook op

15 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

2 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie