Trident - Minecraft Item Frame

A trident for the item frame I designed. This item uses two of the neodymium magnets (check the bottom of the description for the link). I have also included two additional magnet holes that stick out of the model, in case you want to add two extra magnets after the item is finished printing. The profile will have the pause necessary to insert the magnets at the right time. The magnets should fit snug, so no super glue is required to hold them in place. Just be sure to insert the magnets in the right direction so they attach in the item frame correctly! This model is support free and does not require the AMS. If you are not using the AMS, just be sure to add color switch pauses at the same layers as in the print profile. The four different filaments I used in sequence are: SpiderMaker Peacock Green Matte PLA 3DSolutech Mint PLA Inland Light Gray Tough PLA El3goo White Rapid PLA+ The link for the magnets is included in the item frame model on my page: https://makerworld.com/en/models/12