Trimaran Deconstructed Print

The deconstructed files of my trimaran, it doesn't always print right if you have it as a single print, instead of broken up. (The full picture on Makerware is not fully accurate to the actual trimaran, this is an older file.) The longest the hull will usually take is a couple of hours, the arches will probably take around 30 minutes, and the sponsons (side support hulls) usually take around an hour. I haven't printed it that recently so I don't remember the exact time for them. One note about the arches, it is best to print it twice, since usually the right arch will print funny and may not attach right. This was a print that was created as one single entity, so when it is broken down it lacks the necessary angles to fully secure it, so some melting and gluing will be necessary to assemble it. One thing that is helpful is to melt the area on the sponson where the rounded end of the arch will sit and heat up the rounded end of the arch and insert it. When you do this it will make a div