TrimUI Brick Hammer Case

Here is a case I made for the TrimUI Brick Hammer. I made another similar case for the Retroid Pocket Classic. This and the RPC model are adapted from the amazing parametric magnetic storage box that @Mihai_B_Mike made, sized down for the TrimUI Brick Hammer, and then I made some custom inserts to protect the handheld while in the case. This should work just fine for the TrimUI Brick (non-Hammer) version as well, as they are essentially the same handheld. The inserts in this one are a lot more optimized than my RPC inserts, except one problem with this version is that the spot to put your finger to pull out the handheld is a bit small. If you make the inserts out of TPU (which I recommend), it's at least easier because there is a bit of give with the material. Based on the parametric box, you will need 2 - M3 x 30 screws to secure the hinge, and 4 - 8x3mm magnets. The magnets are really more or less a press fit and I haven't glued them in. In fact, with this one as opposed to the RPC v