Trinket Display Shelf

Trinket shelf for all your trinkets, orniments, knick knacks ETC. This is a BIG 9 piece glue together build using approx 2.5 kgs of filament. Superglue/CA glue works well with PLA. The full shelf is made up of 4 corner pieces, 4 mid outer edge pieces and 1 centre piece. Note the thicker edge goes to the outside. Each piece is 200mm x 200mm (approx 8" x 8") for a total size of 600mm x 600mm (approx 24" x 24") Best practice is to place heavier items at the bottom for stabilty. Note build plate preparation is important due to the physical size of each part as the corners are prone to lifting even with PLA. (A little warping may be acceptable as this will be at the back of the shelf and may not be seen.) Boost MeFeel free to boost if you like this model