Thingiverse
Trinus Y Axis GoPro Mount
von afgoody
31
Downloads
16
Likes
0
Makes
I wanted a way to easily mount my GoPro Session 5 to capture time lapses of 3D prints. With a Hero Session 5 mounted, there is still ~1cm of clearance when the print bed is full forward.
The mount attaches to the front end of the Trinus Y axis using 3-4 M3 screws. Since the base is 8mm thick, I'd recommend screws that are at least ~12mm long. The middle top mounting hole is difficult to get to which is why you can see that I did not screw it in, but the other 3 mounting points are stable enough.
The mount attaches to the front end of the Trinus Y axis using 3-4 M3 screws. Since the base is 8mm thick, I'd recommend screws that are at least ~12mm long. The middle top mounting hole is difficult to get to which is why you can see that I did not screw it in, but the other 3 mounting points are stable enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!