Thingiverse
Triple Feed Patch spacer and assembler stand
door DiAleksi
6
Downloads
7
Likes
0
Makes
Here is my method to assemble [Maarten Baert's Triple Feed Patch antenna](http://www.maartenbaert.be/quadcopters/antennas/triple-feed-patch-antenna/).
1. Put 10-12mm wires of 1mm into the holes of assembler till the bottom.
2. Put big pcb on them, solder and cut the rest of the wires.
3. Remove assembler. You'll have 7-8mm wires for the next step.
4. Sand the spacer with fine sandpaper to achieve exact 4mm width.
5. Put on the spacer, small pcb and squeeze them together.
6. Solder wires to the small pcb and cut the rest.
7. Do the rest and voilá.
1. Put 10-12mm wires of 1mm into the holes of assembler till the bottom.
2. Put big pcb on them, solder and cut the rest of the wires.
3. Remove assembler. You'll have 7-8mm wires for the next step.
4. Sand the spacer with fine sandpaper to achieve exact 4mm width.
5. Put on the spacer, small pcb and squeeze them together.
6. Solder wires to the small pcb and cut the rest.
7. Do the rest and voilá.
DiAleksi publiceert ook op
26 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
