Thingiverse
Triple Watch Stand
von Pabzh
120
Downloads
128
Likes
0
Makes
A little watch stand I designed to put my different watches on !
The gap between the little supports is 30mm to make sure that the bracelet goes through.
I printed it in two times : first the body vertically with support for the little supports, and then the feet.
The assembly can be a little rough but a little sandpaper will do the work ! Try not to use too much sandpaper so that you won't need glue.
The gap between the little supports is 30mm to make sure that the bracelet goes through.
I printed it in two times : first the body vertically with support for the little supports, and then the feet.
The assembly can be a little rough but a little sandpaper will do the work ! Try not to use too much sandpaper so that you won't need glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
