Triple XT30 Connector Housing

This housing lets you make a triple XT30 connector. I use this one for extending the PSU cables of my MK3. Print…at 0.2mm using a 0.4mm nozzle. Feel free to use any solid filament. Support is not required. Additional parts / equipment for each housing:1.5mm² braid wiresoldering iron + solder3x male or female XT30 connectors2mm Ø shrink tubings ( usually included )1x 10mm Ø shrink tubing1x 2mm cable tie2x 16mm M3 screws2x M3 nutsSuperglue ( I glued the connectors in the flat part of the housing in order to stiffen them )Hot glue ( Recommended for the male connectors since they are a little bit shorter )AssemblyPut all shrink tubings on the cables. The large one needs to bundle all cables.Strip the cables and solder them to the XT30 connectors. I've seen some connectors with some kind of embossment ( plus minus symbols etc. ) on them. In that case you need to flatten their surface using a file or sanding paper first.Shrink the small tubings.Super glue the connectors to the flat part of t