Thingiverse
Tripod bottom(Y) pivot
von Riker_the_Sergal
3
Downloads
3
Likes
0
Makes
Update May 28, 2018
After some use, the part broke on the thin portion in the back. I went in and made it thicker and added a spot where you can put a nut and bolt through it to make it stronger.
-------------
The bottom pivot broke when I went to Furry Migration this year in MN. After a month I finally made a replacement for it. You will need to run down to the hardware store and pick up one nut and bolt for it. I have also uploaded a wingnut that will work with the matching bolt and nut. The nut is held in by pressure.
After some use, the part broke on the thin portion in the back. I went in and made it thicker and added a spot where you can put a nut and bolt through it to make it stronger.
-------------
The bottom pivot broke when I went to Furry Migration this year in MN. After a month I finally made a replacement for it. You will need to run down to the hardware store and pick up one nut and bolt for it. I have also uploaded a wingnut that will work with the matching bolt and nut. The nut is held in by pressure.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
