Tripod Holder

This is a remix of the remixed Broom holder. It prints all in one piece with Pins in place. (works great) To use, slowly work it back and forth until it moves. I printed it in petg at 20% infill on a ender 3. I have also printed it in pla and it works really well in that filament as well.

The difference from the original is that I have extended the piece out further from the wall so it could hold a tripod against a wall. I also have thickened the back and added 3 screw holes. I also made the tongs at the end longer so they they almost touch when closed. I found the original was leaving a gap when closed and I wanted it closed when holding a tripod so it was less likely for it to fall out.

Overall a great design and for sure one to print if you want to hold a tripod.
Thanks
WoodenCreationz