Tripplight Mounting Bracket

I printed these to mount a Tripplight power strip to the bottom of my stand-up desk. The strip included a way to mount it/hang on a wall, but not upside down. I've since learned that Tripplight makes brackets for this, but I wasn't aware at the time and made these instead.

ABS would probably be stronger, but I've had better luck with PLA so that's what I tend to use for just about everything.

You'll notice the screw holes are a little janky. This was the first functional I-need-a-thing-print I created and it worked well enough for the job so I left it alone. It could stand a little refinement, though. I posted this to /r/functionalprints and a couple of folks suggested that this part be rotated 90 degrees, so that the lamination is perpendicular to the desk. This would make the bracket stronger.