Thingiverse
Tritium keychains duo
door SagittariusArtworks
5
Downloads
7
Likes
0
Makes
The tritium vials you need for this are 3mm x 22,5mm in size.
The holes are 3,05mm big, so they should fit without problems (depends on your printer quality). If not, then use a 3mm drill.
After the vials are inserted, use some epoxy or glue on top to seal them in.
You just need to lay them flat on the surface in your slicer!
The holes are 3,05mm big, so they should fit without problems (depends on your printer quality). If not, then use a 3mm drill.
After the vials are inserted, use some epoxy or glue on top to seal them in.
You just need to lay them flat on the surface in your slicer!
SagittariusArtworks publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
