Thingiverse
TronXY P802 Things
por raymans2
17
Descargas
14
Likes
0
Makes
Here are a couple of parts I created for my printer.
"Y Axis Pulley Mount" is a single piece pulley holder.
"Axial Support" is a multi location support that fits on the threaded rods and bolts up to existing holes on the frame using M3 screws. This will work in any of 5 positions on the rod, except for nearest the Y axis stepper. It probably could be cut to fit this location as well but I'm not going to put one there.
"Frame Support" I built a vertical frame support that fits under the top bracket and into some existing holes in the frame. The holes where about M2 so I had to bore them out to use the M3 screws for this part.
Sorry about some of the pics, the frame is clear acrylic and therefore difficult to show the contrast. Also the old 22cal. does not add any structural support to the printer.
More to come as I build this printer.
BTW I'm not sure but some of these parts MAY be interchangeable with the ANET A8?!
"Y Axis Pulley Mount" is a single piece pulley holder.
"Axial Support" is a multi location support that fits on the threaded rods and bolts up to existing holes on the frame using M3 screws. This will work in any of 5 positions on the rod, except for nearest the Y axis stepper. It probably could be cut to fit this location as well but I'm not going to put one there.
"Frame Support" I built a vertical frame support that fits under the top bracket and into some existing holes in the frame. The holes where about M2 so I had to bore them out to use the M3 screws for this part.
Sorry about some of the pics, the frame is clear acrylic and therefore difficult to show the contrast. Also the old 22cal. does not add any structural support to the printer.
More to come as I build this printer.
BTW I'm not sure but some of these parts MAY be interchangeable with the ANET A8?!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!