TRONXY X3 Bed Support

This is my solution for TRONXY X3 bed wobbling problem.
Based on kencam's solution, I tried to maximize distance between the 400mm rods, allow for both belts orientations (vertical and horizontal) and keep original TRONXY X3 design (motor, end limit switch) as much as possible.
Bed attaches with 4x M3x16mm (not in the pictures, original M5 were used for orientation). Acrylic bed was drilled with a 3mm bit.

Stepper Motor Support (without central 2020 extrusion): https://www.thingiverse.com/thing:2437197
Rod Supports (Low Profile): https://www.thingiverse.com/thing:2437820
Bronze bushings (8mm x10mm x10mm) support: https://www.thingiverse.com/thing:2437855
Bed cable relief: https://www.thingiverse.com/thing:2437865
Carbon Reinforcement: https://www.thingiverse.com/thing:2501346

(belt tensioner (not my design): https://www.thingiverse.com/thing:2021999)