Tronxy X3 simple bed stablizers

I Printed the set in PETG at 60 % infill. You will need to drill a hole in the acrylic plate.

Bill of materials;

2x -8mm x 400 mm guide rod
4x -LM8U bearings
2x -M6 bolts and 10mm nuts(length I don't remember but make sure it doesn't make contact with the guide rod)

I did not use any bolts for the bearings and guide rods because they had a snug fit however these are included in the design (M6 bolts for the bearings M4 for the rods)

The bed doesnt have to be removed for installation, 2 hole are drilled centered on the sides of the plate.(Quick tip use calipers to make the lines!)

Make sure for installation that the bearings run straight and are greased/oiled!