TronXY X5S-2e Calibration Code

**TronXY X5S-2e**
Using the stock 32-bit Chitu closed source board. As this board is currently not supported in Marlin, it is necessary to make changes to the original parameters without reflashing. Fortunately most things can be done through this GCode. Information has been sourced from various areas and translations clarified

I have enabled the *Thermal Protection* as it comes standard disabled.
It is necessary to replace 2 lines with
M8002 I1 ;X stepper motor direction
M8003 I1 ;Y Stepper motor direction
as I have modified the firmware to suit a CoreXY design, rather than the H-Bot design the X5S-2e ships as.
I have also updated the extrusion mm/step value to suit the extruder gear that came with it.

If you find any issues, or further information that could be added feel free to comment.


*NOTICE:* As always, backup your current settings before making changes
To backup: Insert an SD card in the machine and run
M8512 "ConfigBackup.gcode" ;

To run updated co