Troopa Shell Pi 4

Troopa Shell By Troopa Shells
Case concept by Troopa Shells. Designed/edited by Jimmy Johansson.
Case for Raspberry Pi 4. Will be doing a 3b+ and odroid in the future.
This isn't your standard Pi 4 case. This shell is designed to be more a "retro console" more than anything . This is much larger than most pi cases.
What you will need to build :
-6 3m screws. 4 long 2 short .
-60mm fan. Suggested 5v fan .
-2 3mm LEDs .
-a 12mm monetary on switch .
-3 sets of jumper wires. To connect LEDs and power button to gpio board.
-Some paint. Optional.
Instructions: (If painting paint and dry first .)
1. Put SD card into Pi .
2. Figure out where your going to gpio with LEDs, power button and fan. Connect LEDs and power button to gpio. (Optional can do after pi inside case. )
3.Place pi inside bottom case . Carefully
4. Align with screws holes . Put short 3m screws in .
5. Carefully put power button and LEDs in spots in case. Power on left SD activity on right .
6. Place fan