Trophy System

These are the beginning pieces of the trophies I have been 3d printing.

Each trophy requires a base and a plug.

The plug holds a 1/4"-20 nut then fits into the base. A 1/4"-20 x 1 (or 1 1/4) machine screw the goes up through the hole in a weighted trophy base (I get my from other trophy pieces from https://www.trophykits.com/ (I use the 3 5/8" x 4 3/8" Weighted Plastic Trophy Base Black Marble Finish (WPB34BK) more than any other)).

I generally start with the die base, but you can make any base by putting the "base inside.stl" as a 'hole' in whatever base you want.

I then find a cool figure on here and connect it to the plug.
I have included some that I have made
Pip base is a die
Pip plug is the one for the die - I give this as the "Dice Hate Me" trophy.
Die Plug is a plug with a die - so it is two stacked dice.
Brush Plug is my best painted award - created on Tinkercad (using one of "Lincoln's Hands" (in the Featured Collections) - the picture is of a resin ve