Thingiverse
Trouble Counter
by GregFax
1
Downloads
2
Likes
0
Makes
My grandkids lost one of the counters for their board game "Trouble", and that meant only three players!
Ten minutes on Fusion 360, and presto, four players again.
Unfortunately, the game was whisked away before I could get a photo of the finished counters!
Print in the colour of your choice - I found it easier to just print four new counters in the filament I had loaded (black PETG) rather than try to colour match!
Ten minutes on Fusion 360, and presto, four players again.
Unfortunately, the game was whisked away before I could get a photo of the finished counters!
Print in the colour of your choice - I found it easier to just print four new counters in the filament I had loaded (black PETG) rather than try to colour match!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!