Thingiverse
Truss
von Ironsid
0
Downloads
0
Likes
0
Makes
A similar design was needed.
The idea was to put a rod on 4 mm, It turned out to be not enough, but you can choose it right in the slicer for your. Printing is done without support
The idea was to put a rod on 4 mm, It turned out to be not enough, but you can choose it right in the slicer for your. Printing is done without support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!