Thingiverse
Trx-4 Defender crawl bumper
by GenCab
68
Downloads
42
Likes
0
Makes
Check out my etsy store! https://www.etsy.com/shop/HotSquare
I got the idea from thing ID:2501947 but not a remix.
The purpose of this bumper is to get rid of the grabby lip that catches on the back. This bumper combines the factory protection with a low profile. Some corner protection was added that has a nice snug fit to the stock body.
ABS is recommended. If you don't use ABS try to under size the model by 1% for best fit.
SUPPORTS are in the design just snap them off when done.
I got the idea from thing ID:2501947 but not a remix.
The purpose of this bumper is to get rid of the grabby lip that catches on the back. This bumper combines the factory protection with a low profile. Some corner protection was added that has a nice snug fit to the stock body.
ABS is recommended. If you don't use ABS try to under size the model by 1% for best fit.
SUPPORTS are in the design just snap them off when done.
GenCab also publishes on
23 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!