Thingiverse
trx bronco roofrack
von lordleuter
195
Downloads
108
Likes
0
Makes
this roofrack is a bit oversized so that the sides are protected during rollover.
it is printable in 2 pieces that you can glue together
if you like you can scale down in your slicer software.
print this laying flat, support on for the holes.
total size length 260*160*18 mm
it is printable in 2 pieces that you can glue together
if you like you can scale down in your slicer software.
print this laying flat, support on for the holes.
total size length 260*160*18 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!