TRX4-Laydown-Steering-Servo-Mount

As described, a mount that lays down the steering servo in a TRX4.

As I understand, these are commonly used to get more suspension droop. In my case I only wanted to have decent geometry while using one of this clamp on servo horns instead of the stock traxxas one since that was getting wore out and causing a lot of slop. It also gets the servo just a bit lower I suppose. I am mounting it basically as low as it can possibly mount while still getting full compression from the front suspension.

If you use it you'll need to trim the last hole off one of those clamp on servo horns for it to fit.

SMH panhard is such a bother, lol. Would like to come up with a 4 link conversion but I can't help but think the geometry of the upper links will be tricky and interfere with the motor.

You'll notice this is only one half of the pieces you need, Simply copy then mirror the part in your slicer before printing so you get both sides.