trx4m defender 90

Let's be honest, it will take a few hour to build it.
you'll need a few trx4m part: gearbox, skid plate, axle, battery, receiver, body and the
shocks

took me about 3 days of 3d modeling and a few hours of body trimming plus a few more of drive shaft and linkage machining

•First of all, the chassis, print in 4 parts, 2 on each side, "longerons avants" is for the front
part of the chassis, and the "longerons arrières" is the rear one.

•Next, the linkage, i design some that are not adjustable, but at the right length. you can extend the rear axle by using the front link on the rear.
-front upper link :44mm
-front lower link :50.5mm
-rear upper/lower link :43.3mm
•Then, the drive shaft, same as the linkage, stock one doesn't fit
there is not really a measurement for them, i turn them on my lathe until they were at the
great length, i think it's better to buy some plastic one and cut them to length rather than
turning some stainless o