TS80 Soldering Box

I designed this little box for my TS80 soldering Iron to fit my XIAOMI power bank (20Ah QC3 Version). It also holds some solder, the cable, a chemical tip cleaner/tinner, a sponge which is not yet in the pictures as I still need to cut one to size and acts as a stand for the Iron when in use. To use it as a stand you need to put an M8 nut into the print which acts as a heat resistant inteface. Time will tell if it gets too hot during repeated longer time use but I actually got the Idea from another design here on Thingiverse so I thought I'd give it a shot. The stand, which also acts as a lid release, broke off on my print during support removal due to a design flaw I have since removed so the .stl should be fine now. That's what all the ugly glue is about. This was printed on an ender 3 from its backside up using supports. I know using the cable as a bolt there might not be good for it in the long run but the weight is minimal so it should be fine. Hope you guys like it ! Its a chall