Thingiverse
TS9 antenna wall mount
door anra760
1
Downloads
0
Likes
0
Makes
I designed a wall mount for my 2 TS9 antennas for my Netgear nighthawk that I use for my primary source internet. the mount is for a 3cm base round antenna. no supports and no glue required
Recommend printing the round bit flat on the bed, prints a base with no holes
Recommend printing the round bit flat on the bed, prints a base with no holes
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
