Thingiverse
TT02 front splitter
von makeasyougo
54
Downloads
33
Likes
0
Makes
Printed 100% infill
Fitted to a Kenmari
This may or may not fit your chassis/body.
It is attached with two m2 15mm long screws.
**************
6/29/2020 Added 3mm thick splitter with fillet edges. (previously 2.5mm)
Please be careful , if you hit a lip on the road or a large pot hole you may be in danger to flip.(I did do this at Full speed)
Fitted to a Kenmari
This may or may not fit your chassis/body.
It is attached with two m2 15mm long screws.
**************
6/29/2020 Added 3mm thick splitter with fillet edges. (previously 2.5mm)
Please be careful , if you hit a lip on the road or a large pot hole you may be in danger to flip.(I did do this at Full speed)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!