Thingiverse
TTD Logo Monster
43
Downloads
26
Likes
1
Makes
The Tabletop Dungeoneers Logo as a print!
There are a few odd files in here:
Ball - this is because I was having trouble getting stalks to print complete so I wanted just the ball to glue on broken stalks
Eye - same reason as above
Flying piece - this is the pedestal for the base as a separate piece.
New base - this one is scaled to 200% of the original model size and has a recess and hole for putting in LEDs. You'll still need to drill a hole through the "flying piece" if you want to run wires. It prints a lot better solid than with the hole in it if you're doing fdm.
Otherwise you have options of doing it in halves, or as one thing if you're feeling up to it. There are only 4 stalks, but because of the ball joints you can mix match and position them however you prefer. You'll need 9 of them in total.
There are a few odd files in here:
Ball - this is because I was having trouble getting stalks to print complete so I wanted just the ball to glue on broken stalks
Eye - same reason as above
Flying piece - this is the pedestal for the base as a separate piece.
New base - this one is scaled to 200% of the original model size and has a recess and hole for putting in LEDs. You'll still need to drill a hole through the "flying piece" if you want to run wires. It prints a lot better solid than with the hole in it if you're doing fdm.
Otherwise you have options of doing it in halves, or as one thing if you're feeling up to it. There are only 4 stalks, but because of the ball joints you can mix match and position them however you prefer. You'll need 9 of them in total.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!