Tube Connector Extras

These are some extras for tubes. Most has to do with antkeeping, but i might split this up later, I just wanted to get it uploaded.

!!!! Information Below !!!!

Screw And Nut - Probably the most useful thing here. Great way to connect tube through wall or side. All of the screws fit 1/4 tubing in both sides. Made with the Poor Mans's Openscad Screw Library by aubenc.

Important - You may need to print the nuts around 3-4% bigger on the X and Y to fit right. I used the same dimensions as the original but this is what worked for me

End Cap Vents - A vent that fits over 1/4 tubing. I only recommend 0.6, as the others may be hard to print, but the test has all 3 types.

Entrances - Entrances for ants into an outworld. The old entrances were meant for 6mm but work fine for 1/4 inch.

WaterThing - Watering thing for ants. Made for 1/4 tubing. It works good for me, but you will need to silicone up the bottom to stop leaks.

All these things