Thingiverse
tube joiner
door bramfam
3
Downloads
4
Likes
0
Makes
I had a broken Aircon drain tube, so I came up with this simple design.
Version 2, has one end with a softened edge to allow the water to flow easier.
I used PLA to print, with no supports. On my Hictop, it took about 30 minutes to print at a resolution of 0.06.
Version 2, has one end with a softened edge to allow the water to flow easier.
I used PLA to print, with no supports. On my Hictop, it took about 30 minutes to print at a resolution of 0.06.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!